+- Woodnet Forums (https://forums.woodnet.net)
+-- Thread: Garage sale find...$2 (/showthread.php?tid=7378556)
Garage sale find...$2 - bandit571 - 05-24-2025
And..it was the "Pick of the Litter" of the 6 that were all tangled up in a pile...
[attachment=54709]
10" sweep. Chuck WILL hold even the round shanked drill bits...
[attachment=54710]
All it needs is a bit of a clean up....everything works nicely.
Any ideas out there, about who made this drill? Thinking Gooddell Pratt Co. but not sure...maybe a No. 1052?
RE: Garage sale find...$2 - Arlin Eastman - 05-24-2025
If it works it is a good find.
RE: Garage sale find...$2 - stav - 05-25-2025
I didn't know braces were made so they could hold round shank bits. I thought they all used the pyramid shanked bits.
RE: Garage sale find...$2 - bandit571 - 05-25-2025
All depends on the jaws inside the shell....Barber Chucks are more for the square shanked bits...
I guess that is why they came out with the "Hold-All" style chucks...
RE: Garage sale find...$2 - stav - 05-27-2025
I need to look into these Hold All chucks.
RE: Garage sale find...$2 - Admiral - 05-27-2025
(05-27-2025, 07:45 AM)stav Wrote: I need to look into these Hold All chucks.
Yankee 2101s will also hold round shank bits. A lot of people use twist bits in them, but frankly, a brace is not optimal for twist bits at all, they crave RPM, not torque.
RE: Garage sale find...$2 - bandit571 - 05-28-2025
While looking through an old P.S. &W. Catalog, 1910 era...
found this..
[attachment=54719]
Hmmm..
[attachment=54720]
No. 3002, Nickel plated 10" sweep...ring shifter....Same chuck. Same Ratchet...almost the same Price....